Module 5 LASA 2 Country/Industry Risk Analysis

need expert in economic and IT, computer science

module 2 case

communicating health risk

Fujiyama Electronics Case Study

This case study looks at the behavior of a circuit board process through the use of control charts. At least two control charts will need to be constructed, and from them, you will be asked to provide an assessment of what you see. A template to facilitate the construction of the control charts has been attached.You are not required to use this template; however, it will greatly facilitate the solution.

Problem Statement

Fujiyama Electronics Inc. has had difficulties with circuit boards purchased from an outside supplier. Unacceptable variability occurs between two drilled holes that are supposed to be 5 cm apart on the circuit boards. Thirty samples of four boards each were taken from shipments from the supplier. The data obtained can be found on a attached.

Guidelines

The students will complete and answer the following questions.

1. Calculate X-bar-bar, R-bar, and associated control limits using the data in the table above.
2. Create x̄ and R (average and range) control charts from the data in the table above.
3. Discuss notable out-of-control conditions displayed in the completed x̄ and R (average and range) control charts. Only consider points outside the control limits. Do not consider runs, set of points within certain zones, and so forth.
4. If the conditions you note could be defined as assignable conditions, and they are removed from the process, then what will happen to the X-bar and R control chart?
5. Remove the data related to the out-of-control points you observed from the original data, and recalculate new X-bar-bar, R-bar, and associated control limits.
6. Create new X-bar and R (average and range) control charts from your updated data.
7. Discuss how the two sets of control charts are different. What has changed?

The format of the case study should conform to the Publication Manual for the American Psychological Association (APA), 6th edition, for the title page and text. Citations and references are not required. A basic APA tutorial can be found in the Webliography, and a paper template can be found in Doc Sharing. The completed case study will be submitted to your Dropbox as an MS Word document. All graphics and charts will be a part of the Word document and submitted as a file. Documents authored in other applications, such as WordPerfect or MS Works, will not be accepted.

Grading Rubrics

Fujiyama Electronics Case Study Grading Rubric

First Control Chart (40%)	Points Possible	Points Earned	Comments
All calculations are correct.	10
X-bar and R-charts are presented and correct.	10
All conditions of importance are discussed.	12
Total	48
Second Control Chart (40%)	Points Possible	Points Earned	Comments
All calculations are correct.	10
X-bar and R-charts are presented and correct.	10
Differences between the two sets of control charts are thoroughly discussed.	12
Total	32
Mechanics (20%)	Points Possible	Points Earned	Comments
The paper, including the title page, follows APA guidelines for format (references and citations not required).	4
Sentences are complete, clear, and concise.	4
The paper is laid out with effective use of headings, font styles, and white space.	4
Rules of grammar, usage, and punctuation are followed.	4
Spelling is correct.	2
Total	16
Total (100%)	Points Possible	Points Earned	Comments
	80

Best Practices

The following are the best practices in preparing this paper. Sample papers, using APA format, are located in Doc Sharing. Other useful information has also been provided there, including an APA paper template.

• Cover page: Include the person you prepared the paper for, who prepared it, and the date.
• Body of your work: Include titles to identify different areas that you address. State the main ideas, major points in each idea, and supporting information. Break down each main idea you will use in the body of your paper. Show some types of division, like separate sections that are labeled, separate groups of paragraphs, or headers. You would include the information you found during your research and investigation.
• Summary and conclusion: Summarizing is similar to paraphrasing, but it presents the gist of the material in fewer words than the original. An effective summary identifies the main ideas and major support points from the body of your report.

Additional hints on preparing the best possible project include the following.

 

Your hospital is reviewing its medical staff rules and regulations. As the Director of the HIM department, you have been asked to work with the physician Chairperson of the Health Information Committee to make a recommendation regarding a policy on authentication, dating and timing of physician orders, including verbal, telephone, electronic, and handwritten orders. The policy you develop must allow the hospital to be in compliance with the documentation requirements of the Joint Commission, CMS Conditions of Participation and the State Licensing regulations.

Requirements:

1. Research and examine the documentation requirements in each of the following standards related to physicians’ orders for an acute care inpatient facility, including authentication, dating, and timing of orders:
   1. Illinois State licensure rules (www.ilga.gov)
      1. Click on Subpart L Records and Reports
      2. Click on and Review Section 250.1510 Medical Records
   2. CMS Conditions of Participation
      1. Review the CMS Conditions of Participation provided by your instructor.
         1. 482.24 Medical Record Services
   3. The JCAHO standards
      1. Review the Joint Commission Standards provided by your instructor.
         1. RC.01.01.01
         2. RC.00.02.01
         3. RC.01.03.01
2. Prepare a 2-3 page report describing, comparing and/or contrasting the specific standards that apply to the authentication, dating and timing of physician orders, and make a recommendation as to what the policy for your hospital should be.

In order to be in compliance with more than one set of standards the hospital must comply with the strictest standard of the three.

 

Example of One Way to Approach the Assignment Regarding Verbal Orders

List each standard that applies and then select the strictest to include in your policy. Joint Commission Standard RC.02.03.07: Qualified staff receive and record verbal orders. Elements of Performance for RC.02.03.07 3. Documentation of verbal orders includes the date and the names of individuals, who gave, received, recorded, and implemented the orders State Licensure Rules (IL) Section 250.1510 Medical Records b)Organization 5c) Authentication of Medical Record Entries 1) All entries into the medial record shall be authenticated by the individual who made or authorized the entry. CMS Conditions of Participation A-0454: All orders, including verbal orders, must be dated, timed and authenticated promptly by the ordering practitioner … Analysis of the Standards: CMS has the strictest policy of the three as it requires not only dating and signing but timing as well. Recommended Policy: All verbal orders must include the date and time of the verbal order and the name of the individual physician who gave the verbal order. All orders must be authenticated by the ordering physician within 24 hours.

 

Write about the Old Testament of Unit 3

M4:A2

 

Week 8

For this assignment you will write a paper relating a topic in physical science to your career field or other real-world practical application. You must use at least three different sources, and cite them in the paper and on a separate references page.

Introduction

 

Instructions:  In this section, you must do the following:

1. Present relevant background or contextual material.  (Why are you writing on this topic? What is the importance of this topic in terms of your studies, your profession, your life, your activities, etc.)
2. Define terms or concepts when necessary.  ( Do not use acronyms in the introduction, if you plan to use acronyms later in the body of your paper, you must define them now.  Any technical term should also be defined.  If you are writing about a particular concept, ie.  Newton’s Third Law of Motion, then you need to explain the concept here in the introduction)
3. Explain the focus of the paper and your specific purpose. (What will your paper include in terms of research about the topic?  What are the key areas of interest you will be presenting to the readers?  What audience is this paper intended for?  What do you hope to achieve by researching and writing about this topic?)
4. Reveal your plan of organization. (How will you guide your readers?  What is the outline or plan of flow your paper will follow?  The best way to do this is to lay out the key headings of the subtopics that you intend to cover in the main body of the paper)

Body (I would suggest putting down the Sub-headings for each key areas you are covering in your main text body)

Instructions:  In this section, you must do the following:

1. Consider at least 2.5 pages of text – Times New Roman font, size 12, double spacefor your main text body section.
2. Build your essay around points you want to make – flow of ideas and cohesion of ideas are important here.  Do not try to arrange information from sources in a cut and paste manner.  Read the information from sources, put the information in your own words and then organize the information around the key points/topics that you wish to emphasize.  In order to do this, you must draft the paper first.  Drafting is not the final copy.  A draft helps you organize the information.  The final paper is a polished copy that shows how paragraphs are linked, how information is organized to support ideas and thoughts and how the key topics are covered in a cohesive and logical manner.
3. Integrate at least three sources into your writing .  These three sources must come from valid sources.  Do not use wikepedia, Yahoo answers, Ask.com; Answers.com or any websites that do not have a credited author listed.  If you are in doubt, post a question on the Final Paper Thread and let me help you evaluate your sources.
4. Summarize, analyze, explain, and evaluate referenced work rather than merely reporting it. (You summarize information when you put it in your own words, rather than cutting and pasting direct wordings from sources.  You analyze the information when you examine it critically, ask questions about the information, challenge it or locate other supporting sources to validate it.  You evaluate information when you examine it for usefulness, validity, errors, or future application).  Simply putting down the researched information without this personal perspective means that you are only reporting the information.)
5. Move up and down the “ladder of abstraction” from generalization to varying levels of detail back to generalization.  (The general level is the writing in the introduction section, the details are in the body section and the generalization is in the conclusion section.)

 Conclusion

 

Instructions:  In this section, you must do the following:

1. A summary of the information is done here.  Summarize the key points you made in the paper for your reader.
2. If prior to your conclusion you have not yet explained the significance of your findings or if you are proceeding inductively, use the end of your paper to add your points up and to explain their significance.  Physics is a field of study that is applicable to many aspect of your life.  This is where you need to tie the research back to practical applications, whether it be in leisure, sports, work, school, daily activities, etc.
3. Move from a detailed to a general level of consideration that returns the topic to the context provided by the introduction.  A good conclusion will reiterate the key points mentioned in the introduction.
4. Suggest what about this topic needs further research. This is important because it shows a higher level of thinking.  In this area, you would want to take the information you researched and presented to the next level by either theorizing or providing concrete applications of the topic of research for the future.  Again, this could be future applications in school, work, industries, recreational activities, etc.

Personal Evaluation

 

Instructions:  In this section, you must do the following:

1. State your opinion in the first sentence of the paragraph.
2. In the body of the paragraph, give at least three reasons why you think and feel as you do. Include both facts and examples to supportyour opinion.  To support your opinion, you will need an in text citation from one of your sources.
3. End with a sentence that sums up and restates your opinion.
4. Suggest what, if any, improvement should be applied to your topic.
5. Write an appreciation statement regarding the connection of physical science to the world in which we live; discuss how this topic has helped you in your career or everyday life.
6. Most importantly, keep in mind:  this paper must be in your own words.

References (on a separate page)

1. Citeat least three sources using APA format.  If you do not know how to do in text citations or how to set up a particular source in APA, post a question in the Final Paper Thread in the discussion or send me an email and I can help you.

Reasearch

Purpose: The purpose of this assignment is for you to write an original research paper on an ethical, historical, or cultural issue related to advertising. This is a research paper, it should be focused on specific details that emerge from your research. The paper should be the culmination of primary and secondary research on the topic of your choice and be a sustained investigation of an issue that answers a research question you create.

Final Deliverables:

• Research Paper: 3500-5000 words of original research that answers a research question.

 

Research Proposal

Calvin Klein’s “My Calvins” Campaign

1.              Calvin Klein new advertisement campaign “My Calvins” is the most scandalous so far.
2. The campaigns tagline is “raw texts, real stories”.
3. The campaign includes lustful images and persuasive content.
4. It encourages that digital dating and meeting strangers is a norm.
5.               My Calvins video advertisements include raw texts and stories people can relate to.
6. Most of the ads involve teenagers texting and looking for a hookup.
7. The ad videos clearly do not focus on the fashion side but rather more on the sexual side.
8. It includes stories about people’s sexual life that customers can relate to.

III.                Calvin Klein’s new campaign is targeting the millennial generation through social media.

1. The ads contain images and text screenshots portraying erotic conversations similar to tinder texts.
2. This campaign is about starting a conversation with the involvement of provocation.
3. CK will be partnering with tinder within the coming months.
4.              My Calvins campaign lets the famous and non-famous share latest CK wears under the hashtag #mycalvins.
5. Intsagram has become CK’s main target to promote their products.
6. The brand saw an advantage in the selfie obsession, encouraging customers to promote CK’s products under the hashtag #mycalvins.
7. Millions of photos get uploaded and seen on social media.
8.              Purpose of research is to talk about the advantages and disadvantages in advertisement in CK’s new campaign.